AneX m/type PRO Manuel D'entretien page 8

EN
frame, turn the adapters according to the road
type: flat road (hard mode)/mountain road (soft
mode) (Fig. 15). Always adjust both sides in the
same way.
Carrycot
To mount the carrycot, place the adapters into
the adapter pockets located on the inner side
of the frame (Fig. 16). The carrycot adapters are
blocked automatically. To take the carrycot off,
press the memory adapter buttons and lift them
up (Fig. 16). If necessary, the internal part of the
carrycot can be removed and washed. For this,
you should take out the mattress and remove
the coating by opening the two zippers (Fig. 17).
The carrycot is also equipped with a ventilation
system which can be adjusted at the bottom
part (Fig. 18). To adjust the ventilation system,
turn the switch into a respective mode (on/off).
Carrycot hood, carrycot cover
The carrycot features a conveniently foldable
hood protecting a child from wind, sun, snow
and rain. Memory buttons adjust the stroller's
hood positions. There is no need to press both
buttons in order to fold the hood; it is enough
to consequently press one button all the way
in (until you hear a distinctive sound), and
then press the other button and fold the hood
with one hand (Fig. 19). To unfold the hood,
you should simply pull it until it is fixd in the
required position. The carrycot is equipped
with an additional handle for transportation
(Fig. 20). The carrycot is also equipped with a
foot cover, which is attached to the front side
of the carrycot and is fixed with two magnets
on each side (Fig. 21). The hood of the carrycot
is ventilated. For ventilation, unstrap the zipper
and turn back the bottom part of the hood
(Fig. 22). Additionally, the carrycot is equipped
8
with a mosquito net (Fig. 23) and a raincover
(Fig. 24), the latter being suitable for both
the carrycot and the seat unit (Fig. 25).
Seat unit
To mount the seat unit, place its adapters into
the adapter pockets located on the inner side
of the frame (Fig. 26). The adapters of the seat
unit are blocked automatically. There are two
possible positions for the seat unit: the one
facing towards the direction of travel and the
one facing the mother. It is also possible to
remove the textile part of the seat and wash it.
To do so, you should dismantle the textile kit
from the plastic base by carefully unfastening
all the fixating buttons and removing safety
belts. To remove the seat unit from the frame,
press the memory adaptor buttons and lift it
up (Fig. 27). The height of the seat unit back
can be adjusted with the help of the handle
located at the back side of the seat (Fig. 28).
Seat unit hood, foot cover
The seat unit features a conveniently foldable
hood protecting a child from wind, sun, snow
and rain elements. The hood position can be
adjusted by pressing on its upper part (Fig. 29).
The seat unit is also ventilated. To ventilate
it, unstrap the zipper, turn up the upper part,
and lower the hood (Fig. 30). If necessary, the
hood can be removed and washed. For this,
unstrap the zipper on the metal case of the
hood (Fig. 31), remove two elastic bands,
and unbuckle the buttons on the seat back.
To fasten the hood, follow the steps in reverse
order. The seat unit is also equipped with a foot
cover, which can be attached to the inner lateral
sides of the seat unit and to the middle of the
bumper with the help of buttons (Fig. 32).