Footrest Adjustment - AneX AIR-X Manuel D'entretien

hood is ventilated. To achieve proper ventilation,
you need to unzip the upper part (fig. 11). If you want
to wash the hood, you can unzip it and remove all
the latching parts from the frame and the hood (fig.
12, 13, 14). You can also remove the seat from the
frame. To do that, you need to unfasten the Velcro
clasps under the seat and the footrest (fig. 16), then
successively remove all the fastening mechanisms
from the latch pockets (fig. 15).

FOOTREST ADJUSTMENT

Press two buttons located on both sides of the
footrest simultaneously and adjust the required
height (fig. 17). You can lift the footrest with a light
upward push without using buttons.
To get easy access to basket - just pull footrest up
from horizontal position.
STROLLER'S SECURITY BARRIER
The stroller has a bumper to which the protection
is latched. It doesn't allow the child to climb out
of the stroller. To install the bumper, insert it into
the latch openings that are located on both sides
of the stroller (fig. 18). You don't need to press the
bumper buttons. When you need to remove the
bumper, press the buttons located on both sides
of the bumper and slightly pull the handle towards
yourself (fig. 19). For your convenience, each
bumper side can be unlatched separately since it
features flexible latching elements.
SAFETY BELTS
The seat unit features 5-point safety belts. To secure
a child with protective belts, insert the safety belt
locks into the grabber and tighten those belts (fig.
20). To change the position of the upper seat belts