Footrest Adjustment - AneX e/type Manuel D'entretien

EN
If necessary, the internal part of the carrycot
can be removed and washed. To do so, you
should take out the coconut mattress and
remove the coating by opening the two zippers
and fasteners (Fig. 16).
The carrycot is also equipped with a ventilation
system which can be adjusted at the bottom
(Fig. 17). To adjust the ventilation system, turn
the switch into a respective mode (on/off).
Carrycot hood, foot cover
The carrycot features a conveniently foldable
hood protecting a child from wind, sun, snow
and rain elements. Memory buttons adjust the
stroller's hood positioning. There is no need
to press both buttons in order to fold the hood;
it is sufficient to consequently press a button
on the first stage of the adjustment all the way
in (until you hear a distinctive sound), then
press the button on the second stage of the
adjustment and fold the hood with one hand
(Fig. 18). To unfold the hood, you should simply
pull it until it is fixated in the required position.
The carrycot is equipped with an additional
handle for transportation (Fig. 19). The carrycot
is also equipped with a foot cover, which should
be installed at the front part of the carrycot
and fixated with magnets (Fig. 20). The carrycot
's hood is ventilated, you should unzip it first
and then press the memory buttons to lower
the canopy (Fig. 21). Additionally, the carrycot is
equipped with a mosquito protection net (Fig. 22)
and a rain protection cover (Fig. 23), which fits
both the carrycot and the seat unit (Fig. 24).
Seat unit
To mount the seat unit, place its adapters
into the adapter pockets located on the frame's
inner side (Fig. 25). The seat unit's adapters
are blocked automatically. There are two possible
8
positions for the seat unit: facing the direction
of travel and "facing mom." It is also possible to
take the textile part of the seat and wash it. To
do so, you should dismantle the textile kit from
the plastic base by carefully unfastening all the
fixating buttons and removing safety belts. To
remove the seat unit from the frame, press the
memory adaptor buttons and lift it up (Fig. 25).
The back of the seat unit can be adjusted for
height with the help of the handle at the back
side of the seat (Fig. 26).
Seat unit hood, foot cover
The seat unit features a conveniently foldable
hood protecting a child from wind, sun, snow and
rain elements. To set up the hood, adjust its back
side to the seat's back by using the buttons (Fig.
37) and insert the outstanding hood straps into the
correlating spots on the strolling block, until you
hear the clicking sound (Fig. 38). To take off the
hood, you need to slightly untuck the straps fixator
on the seat by using a delicate instrument until the
strap is fully out (Fig. 39), take it out of the seat
and then disconnect the hood from the strolling
block by using the two buttons in the back side of
the strolling block (Fig. 37). The hood position is
adjusted by pressing on its top (Fig. 27). To lower
the hood all the way down, unzip the additional
zipper next to the ventilation spot (Fig. 28).
The strolling block's seat is also equipped with
a foot cover which can be fixated on the inner
lateral sides of the strolling block's seat and on the
middle of the barrier by using buttons (Fig. 29).

Footrest adjustment

To lower the footrest, simultaneously press the
buttons on both sides of the footrest and adjust
to the required height (Fig. 30). The footrest
can be lifted without pushing any buttons.