Satellite Search - Megasat Caravanman Kompakt 3 Mode D'emploi

3. Satellite search with the control unit

3.2 Satellite search

1. Switch the control unit on at the standby button.
2. The search LED flashes green during the search process.
3. The satellite LED of the last used satellite flashes green.
To change the satellite, you must change the satellite with the arrow
4. keys within approx. 3-5 seconds while the LEDs are flashing. Later
changing is only possible if the antenna has found a satellite before.
Confirm the satellite selection with the OK button or wait 3-5 se-
5.
conds until the satellite logs in automatically.
After the selected satellite has been found, the reception LED will
6.
light up orange.
7. If the selected satellite was not found, the Error LED will light red.
After successful search, you can switch off the control unit again at
8.
the standby key.
Note:
If you want to start the search at another location, simply press the Standby
key to search for the last selected satellite.
Retract the antenna to the home position
1. If necessary, switch the control unit on at the standby button.
2. Press the STOW button to retract the antenna.
ENGLISH 13