Indoor Installation - Megasat Caravanman Kompakt 3 Mode D'emploi

2. Installation

2.3 Indoor installation

1. The coax cable is laid inside the vehicle.
2. When choosing the location for the control unit and the satellite receiver,
make sure that both devices are in a dry and protected place.
3. Do not place the control unit and satellite receiver near heat sources and
ensure sufficient ventilation.
4. The basic connection options for the antenna system are shown below:
ƒ Connect the power supply (red-black cable) for the control unit to your
vehicle's battery via a fuse (7 amps) to prevent cable fire in the event of
a short circuit. The yellow cable is connected to the ignition plus of the
vehicle and is also protected by a 7 amp fuse (This cable only needs to
be connected if the antenna is to retract automatically when the engine
is started). The remaining black cable is connected to the corresponding
negative pole of the ignition system (ground).
ƒ Connect the coax cable from the antenna to the control unit
(10 m coax cable with F-plug in „ANTENNA")
ƒ Connect the control unit to the TV or satellite receiver
(1 m coaxial cable with F-plug from „RECEIVER" to the satellite receiver)
Note:
With the Caravanman Kompakt 3 Twin you connect a second coaxial cable
from the antenna directly to the second TV or satellite receiver.
ENGLISH 07