Startup And Operation; Dip Switch; Search For The Satellite - Megasat Countryman GPS plus Mode D'emploi

4. Startup and operation

4.1 DIP switch

DIP switches are located on the back of the control unit. The
default setting for the switches is automatic mode (both
DIP switches are in the upper position). You should only use
the antenna in automatic mode. The mode switch is inten-
ded for service, so you should not change the position of
the switch arbitrarily.
WARNING!
If the antenna is not in automatic mode, it does not function as described in this
manual!
If you still want to operate the antenna in manual mode, no guarantee is granted!

4.2 Search for the satellite

1. Switch on the control unit. Subsequently, some satellite LEDs will light up. These show
the current firmware version as a binary code. The display usually only serves the
service.
2. As soon as the control unit is ready for operation, one of the satellite LEDs lights up.
3. If you want to search for another satellite, press one of the arrow buttons to select the
desired satellite. Confirm selection with the SET button to start the search.
4. Before the satellite search, the home LED flashes and checks the antenna status (po-
sition). If the antenna is not in the HOME position, the antenna goes into the basic
position before it searches the selected satellite.
08
checks the position
search for satellite /
Binary code shows the
current firmware version
ENGLISH
automatic
mode
manual
mode
Satellite found