Star SP200F Série Mode D'emploi page 14

4-2-2. Loading the Paper
FEED
switch
Fig. 4-12 Removing the cover
Roll paper
Fig. 4-13 Loading the paper
Cover
1 Lift the cover up approx. 3cm. Hold
2 Cut off the front edge of the roll
3 Confirm that the power of the printer
4 While observing the direction of the
Core
Axis
5 Move the paper roll holder in the
Paper roll holder
6 If the paper roll core has not been
– 11 –
the cover tilted at this angle, then
pull it toward you to remove it.
paper perpendicularly.
is turned on.
roll paper, insert the top end of the
paper beneath the paper guide as far as
it will go. If the roll paper is installed,
the top end of the paper automatically
comes out from the paper exit. After
2cm of paper are fed out, the paper
is automatically cut off.
direction of the arrow, and insert the
roll so that the holes in the core align
with the axes of the paper roll holder.
Release the paper roll holder to se-
cure the paper.
properly aligned with the paper roll
holder, the cover cannot to properly
seated until the paper position is
corrected.