Enduro autoSteady AS101 Manuel D'utilisateur page 42

After activating the "AUTO" lower function, before the corner steadies lower, there maybe have a delay about 3
seconds. If one or more corner steadies are not at the complete draw back position, these corner steady will be
draw back for about 3 seconds first.
When the AUTO function process is finished, there will be a beep.
Since the autoSteady system is not equipped with an automatic levelling system, it can happen that the
caravan is not completely levelled out anymore. This can be caused by the use of a flexible jockey-wheel, or a
different spreading of the weight of your caravan or a different friction in the corner steady.
If needed, you can adjust every corner steady individually and slightly level out your caravan again.
The single corner steady function is used to adjust the height of single corner steady a little.
Do not try to jack the caravan by this function, this could completely damage your caravan
chassis or floor.
Different caravan chassis or floors have different situation for jack-up force. Using the
single corner steady function button have the possibility to completely damage your caravan
chassis or floor. The stop setup on the single corner steady function is used to protect the
motor and control box, it cannot protect your caravan chassis or floor all the time (this due
to the various caravan models).
In general we recommend to use only the "AUTO" function.
After operation, deactivate the autoSteady system by moving the slide switch (Fig. 10A) to "Off"-O on the
remote control. The LED (Fig. 10I) on the remote control will turn off. Store the remote control in a safe place
(out of reach of children or other unauthorized people).
Turn off the battery power isolation switch (24).
When you want to draw back all the corner steady, you act as following:
Before starting the operation of the system, the handbrake must be secured and the jockey
wheel must be tightly fixed and tough the ground.
Turn on the battery power isolation switch (24).
Activate the autoSteady system by moving the slide switch to "On"-I on the remote control (Fig. 10A). The
green LED (Fig. 10I) will illuminate and you will hear a short beep. The system is ready for use.
First press the "UP" (Fig. 10B) button. You will hear a short beep and the red LED in this button will illuminate.
Press for at least three seconds the "AUTO" button (Fig. 10D). The red LED of the "AUTO" button (Fig. 10D) will
blink during these three seconds and every second there will be a beep. This is warning you that the system will
be activated.
After these three seconds the auto function will start and the corner steadies will automatically act. The red LED
of the "AUTO" button (Fig. 10D) will illuminate constantly. Now you can release the AUTO button.
The corner steady will act as following:
first the two front corner steadies (Fig. 8A and Fig. 8C) draw back completely
•
than the two back corner steadies (Fig. 8B and Fig. 8D) draw back completely
•
When the AUTO function process is finished, there will be a beep.
After operation, deactivate the autoSteady system by moving the slide switch (Fig. 10A) to "Off"-O on the
remote control. The LED (Fig. 10I) on the remote control will turn off. Store the remote control in a safe place
(out of reach of children or other unauthorized people).
Turn off the battery power isolation switch (24).
Before you start driving always make sure that the four steady feet are fully lifted! Please
check the one by one!
Individually adjustment:
First choose the "UP" for draw back or "DOWN" for lower by press the button.
Press the single corner steady function button (Fig. 10E,F,G,H) to lower or draw back individually. The corner
steady will move if the single corner steady function button is kept pressed. It will stop if the button is released.
EN ® autoSteady 36
DURO
Ref: AS101-UM-TKI-1212-Rev. A