Description And Installation - Funkwerk elmeg CS410 Notice D'utilisation

19 Five programmable function keys with LED: Each button has an inset two-color LED
(level 1 - red / level 2 - yellow). These LEDs can be used to indicate certain functions.
20 Label panel for function keys
21 Call signaling (red) and answering machine (yellow) LED

Description and Installation

These operating instructions describe only the most important routines for using the telephone.
Detailed information and documentation can be found on the CD-ROM.
CS410
This system telephone is designed for connection to an internal S0-port (4 wires) of an elmeg pabx system.
If you wish to connect the telephone to an internal Up0-port, be sure to install the internal Up0/S0-module
into the telephone or use the external Up0/S0-converter.
CS410-U
This system telephone is designed for connection to an internal Up0-port (2 wires) of an elmeg pabx sys-
tem. The internal Up0/S0-module or the external Up0/S0- converter are then no longer required.
CS400xt
This system telephone is delivered with a key extension module (T400/2), providing you with 10 additional,
freely configurable keys.
It is designed for connection to an internal S0 port (4-wire cable) of a PABX system. The system telephone is
not equipped with a USB or serial port for configuration or other uses. This phone must be configured via
the internal ISDN port using the WinTools Professional Configurator. There are also no »Audio functions«
implemented and you can not use the Answering machine or Up0 modules or functions. None of the
functions for this module are shown in the display, nor can they be used.
OFF
ON
elmeg IP-S400
Connect this system telephone to the corresponding LAN port (or network) of the PABX system using a Cat.
5 cable. The system telephone is equipped with a PC output that can be used to connect other IP terminal de-
vices.
Setting up/ Configuring the system telephone
On the system telephone itself you can only carry out a limited configuration of the supported features. A
full configuration is only possible with an elmeg telephone system using the professional WIN tool configu-
rator via the corresponding system telephone interface.
You will find additional information on the configuring of the system telephones in the detailed
instruction manual on the CD-ROM.
This telephone is equipped with the function »Emergency operation«, mea-
ning it can be operated at NT via the PABX system on a loss of 230 V~ po-
wer. Please note that your PABX system supports this feature and that it can
not be used via a Up0/S0 converter.
English
3