Multiplex Razzor RR 26 4280 Notice De Construction page 13

Residual risks
Even if the model is operated in the correct manner, and you observe all safety aspects, there is always a
certain residual risk.
For this reason it is mandatory to take out third-party liability insurance. If you join a club or flying association,
insurance is usually available or included in the annual fee. Make sure that your insurance cover is adequate
(i.e. that it covers powered model aircraft). Always keep your models and your radio control equipment in
perfect order.
The following hazards may occur owing to the model's construction and type:

Injury caused by the propeller: you must keep well clear of the area around the propeller from the
moment that the battery is connected. Please bear in mind that objects in front of the propeller
may be sucked into it, and objects behind the propeller may be blown away by it. The model may
start moving when the propeller starts to turn. You must therefore position the model in such a way
that it cannot move towards other persons if the motor should unexpectedly start running. When
you are carrying out adjustment work involving the running motor, you must ensure that the model
is always held securely by an assistant.

Crash caused by pilot error: this can happen even to the best of pilots, so it is essential to fly
exclusively in a safe environment: an approved model flying site and suitable insurance are basic
essentials.

Crash caused by technical failure or unnoticed damage in transit or in the workshop. A thorough
check of the model before every flight is essential. However, you should also take into account at
all times that material failures can and do occur. Never fly in a location where your model may
damage or injure others.

Keep within the stated operating limits. Excessively violent flying will weaken the airframe, and
may result in sudden material failure, or may cause the model to crash during a subsequent flight
due to "creeping" consequent damage.

Fire hazard caused by electronic failure or malfunction. Store batteries safely, and always observe
safety notes which apply to the airborne electronic components, the battery and the battery
charger. Protect all electronic equipment from damp. Ensure that the speed controller and battery
are adequately cooled.
The instructions which accompany our products must not be reproduced and / or published, in full
or in part, in print or any electronic medium, without the express written approval of Multiplex
Modellsport GmbH & Co. KG.
Specification Razzor
Wingspan:
Overall lengh:
All-up weight:
Total surface area:
Wing loading:
Channels:
RC Functions:
620 mm
595 mm
300 g
9,1 dm²
33 g/dm
4
Rudder, elevator, throttle, ailerons
13