u
5 3
2
.
0
9
F
%
-
1 0
0 0 .
%
u
-
1
0
.0
%
-
1
9
8 6 .
u
5 2
4
.
6
9
8
2.3 Plus/minus and percent weighing
Preparation
Set Unit 2 in the configuration register to "%" as described in the operating instructions of the
balance in the section "Configuring – Unit selection".
Load or weigh in target weight (reference weight).
Store reference weight: press key ©.
Remove target weight and load the weight to be compared or again weigh in to target weight. The
result appears in % of the reference weight.
Notes
If the © key is pressed again, the weight currently loaded will be stored as a new target weight
(100 %).
Checkweighing, coarse and fine weighing-in as described in the operating instructions of the
balance.
Switching between percent and weight display:
press key ª.