Installation And Putting Into Operation; Installation And Configuration; Connecting To Power Supply - Mettler Toledo Fieldbus Guide Rapide

1 Introduction
The METTLER TOLEDO Fieldbus modules allow to connect METTLER TOLEDO weigh modules to an
industrial Fieldbus network and make it possible to control the weighing sensor with a PLC master. For
each weighing sensor is a separate Fieldbus module required.
The following Fieldbus modules are currently available:
Fieldbus module
METTLER TOLEDO Profibus module
METTLER TOLEDO DeviceNet module
METTLER TOLEDO EtherNet/IP module
METTLER TOLEDO ProfiNet IO module
METTLER TOLEDO CC-Link module
2 Installation and Putting into Operation
2.1 Installation and configuration
To install and configure the Fieldbus-Module proceed as follows:
1 Configure the weighing sensor.
2 Mount the DIN-Rail.
3 Connect the Fieldbus-Module to a PC for initial configuration.
4 Connect the Fieldbus-Module to the weighing sensor.
5 Connect the Fieldbus-Module to a power supply.
6 Configure the Fieldbus-Module and activate the changes in the Fieldbus-Module.
7 Connect the Fieldbus-Module to the Network and check the LED indications.
For further details on these instruction steps, see Operating Instructions.
Documentation Fieldbus-Module
2.2 Connecting to power supply
The power supply connector is located at the bottom of the Fieldbus-Module.
Pin Description
1 + 24V DC +/- 10%, 280mA max.
2 GND
An appropriate connector with screw terminals is included in the delivery (connector type MSTB
2.5/2-ST-5.08). The appropriate cable diameter ranges from 0.2 mm
AWG 12).
Part number
42102809
42102810
42102860
42102859
30038775
u www.mt.com/ind-APW-fieldbus-support
Fieldbus
1 2
2
to 2.5 mm
Power connector
2 -
+ 1
2
(AWG 24 to
Introduction 1