Installation In Version A Balances - Mettler Toledo GM303 Mode D'emploi

1.3 Installation in version A balances

• Remove Phillips screw (6).
• Mount GM303 using the screws with fine-pitch thread in screw set A as shown in the illustration.
6
• Route connection cable.
7
• Mount cable guide with the self-tapping screws of screw set A.
• Attach GM303 to the GM socket of the balance.
• Degrease housing base in the region of the rear foot using acetone.
• Stick on adhesive foot (7).
• Start up balance and level.
Note
It is advisable to calibrate the balance after approx. 1 hour.
4