RS Pro IDM201N Manuel D'instructions page 5

 CaUTIoN
• Disconnect the test leads from the test points before changing the position of the function rotary switch
• Never connect the instrument to a source of voltage with the function rotary switch in Ω/
• If possible, do not work alone, so assistance can be given if required
• Do not expose the instrument to extremes of temperature or high humidity
• When connecting the test leads to a circuit or device, connect the black lead before the red lead and disconnect the red lead before the black lead
• If the instrument is used near equipment that generates electro-magnetic interference, the display may be unstable or indicate incorrect measurements
• When measuring current using the 10A range, the maximum measurement duration is 30 seconds in any 10 minute period for currents greater than 10A
The following symbols may appear on the instrument and in this Instruction Manual:
Risk of electric shock

Refer to Instruction Manual

Direct Current (dc)
Equipment protected throughout by double or reinforced insulation

Battery
Fuse

Earth

Alternating Current (ac)

Conforms to applicable EU directives

/A  //Hz position

5