Festo DG Serie Mode D'emploi page 17

S
Remove the packing.
This is intended for recycling (except for oiled paper which must be disposed of).
S
Please comply with national and local safety laws and regulations.
S
Please use the product in its original state without undertaking any modifica-
tions.
5 Fitting
Note
If the shaft is damaged, it will not be poss-
ible to synchronize the axes.
S Check to see whether the connecting
shaft shows any signs of transport or
storage damage, especially buckling,
dents or bending.
A KSK-... with such damage cannot be
used further.
S
Measure the positioning path k of the
slide on both axes for each revolution of
the drive pin.
The parallel structure permits a static
total offset of the slides to each other over
the total positioning path of the axes as
shown in Fig. 23.
The smaller the deviation D k of the feed constants, the better the two axes will
harmonize with each other (see chapter Characteristic curves).
Festo KSK-... 0010NH English
Fig. 4
k
Fig. 5
17