Publicité
Mazda 2
2003 - ....
Ref.
Fitting instructions
1)
Disassemble the bumper and loosen the exhaust out of the suspending rubbers.
2)
Place the mounting plates (-g) left and (-h) right with the drillings on the provided holes in the outside of
the chassis beams, insert the nut pieces (-i) and (-f) through the big openings in the underside of the
chassis beams till furrow the drillings where the side plates will be fixed. Insert the bolts but do not
tighten.
3)
Place the tow bar with the points (D) and (D') between the mounting plates till the drillings match each
other, insert the bolts, screw everything
4)
Make an incision in the underside and in the inside work of the bumper as on drawing enclosed, the
support in the middle of the bumper may be removed completely. Re-assemble the bumper on the
vehicle.
5)
Assemble the ball on the pedestal of the escamotable system T35, insert the bolts and tighten firmly.
Composition
Tow bar reference 1422
1 ball T43M002
4 bolts M12x40 - DIN933
8 security washers M12 - DIN128A
1 security shackle (-s) (800053)
4 bolts M10x40 - DIN933
4 security washers M10 - DIN128A
4 bolts M12x35 - DIN933
2 nuts M12 - DIN934
2 nut pieces (-i)
2 nut pieces (-f)
1 mounting plate left (-g)
1 mounting plate right (-h)
All bolts and nuts : quality 8.8
Note
Please consult your cardealer or owners manual for the maximal permissable towing mass.
Remove any bitumen coating on the fastening position for the tow bar.
When drilling, be carefull not to damage any brake lines, electrical wiring or fuel lines.
1422
firmly on (see tension).
(*-*')
(*-*')
(*-*')
(*')
(A-B-C)
(A-B-C)
(D-D')
(D')
(A)
(B-C)
(D-D')
(D-D')
Publicité
