Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Anti-tip Bracket Installation
To reduce risk of range tipping, secure range with a
properly installed anti-tip bracket.
1. Remove storage drawer from range.
• See "Removing Storage Drawer" section.
2. Unscrew leveling legs so when range is moved into
position rangetop clears countertop.
• Left or right rear leveling leg must extend at least
¼ inch (6mm) to engage bracket.
• Anti-tip bracket can be installed on either right or
left rear leveling leg.
3. Move range to where it will be installed.
4. Position anti-tip bracket.
• With range in position, reach through storage
drawer opening and slide anti-tip bracket on either
left or right rear leveling leg. Slide leg into V-
shaped notch in bracket.
5. Mark location of side and front of anti-tip bracket on
floor.
6. Remove anti-tip bracket and range from opening.
7. Position anti-tip bracket according to lines marked on
floor.
8. Mark 2 hole locations in anti-tip bracket.
9. Drill 2 holes.
• If drilling into wood, use a
• If drilling into concrete, use a
bit and insert plastic anchors.
10. Secure bracket to floor using screws supplied.
11. Slide range into position.
• See "Level Range" section of manual.
12. Confirm anti-tip bracket is engaged with range
leveling leg and replace storage drawer.
or
3
/
inch drill bit.
32
3
/
inch masonry drill
16
Level Range
Carefully level range using legs provided. Range must be
level to cook and bake uniformly.
CAUTION
To avoid damaging oven door, do not lift or move
range by oven door handle. Glass can break.
• Place a level on top oven rack or on top of range
when leveling.
• Leveling legs must be extended a minimum of
¼ inch (6mm) to engage anti-tip bracket.
1. Extend leveling legs so when range is moved into
position rangetop clears countertop.
2. Slide range to where it will be installed.
• Position range so that rear leveling legs do not
engage anti-tip bracket.
3. Turn leveling legs to level range.
• Turn legs clockwise to decrease range height or
counter clockwise to increase range height.
• Adjust rear leveling leg that engages anti-tip
bracket first. Leveling leg can not be adjusted while
in bracket. After adjusting leg that engages anti-tip
bracket, slide range forward until leg engages
bracket, and adjust other legs.
4. Replace storage drawer.
Removal and Replacement of Range
1. Disconnect power to range.
2. Slide range forward.
3. Unplug range cord and place range aside.
3. Remove anti-tip bracket.
4. Install anti-tip bracket into new location using
instructions provided with bracket or see "Anti-tip
Bracket Installation" section in this manual.
5. To reinstall range, follow instructions in "Installation"
section of this manual.
8
Publicité
Chapitres
Table des Matières
