Fitting The Filter Cover - Gaggenau AC270101 Notice D'utilisation Et De Montage

15 Plug the cable on the appliance into the connecting
terminal and insert it in the strain relief.
16 Close the cable cover.
17 Carefully lift the frame cover.
18 Place the ends of the cable behind the frame cover.
19 Securely tighten the frame cover with the lock nuts
finger-tight.
Note: Do not use a tool to avoid damaging the
frame cover.
20 Remove the spacer from the appliance.
21 Connect a power supply.
22 To start the reference movement, press the Ç
button on the remote control.
Note: A reference movement is used to determine
the correct actual position using a reference switch.
The appliance moves up.
23 If the appliance has moved up as far as it will go,
press the Æ button on the remote control.
The appliance moves down. The reference
movement ends when the appliance has moved
down as far as it will go.

Fitting the filter cover

m
Warning – Risk of injury!
Components inside the appliance may have sharp
edges. Wear protective gloves.
m
Warning – Risk of injury!
Risk of trapping body parts when opening and closing
the hinges. Keep your hands away from the hinges.
Set the required appliance height using the Ç and
1
Æ buttons on the remote control.
Note: If you have not yet performed a reference
movement, the appliance first moves fully up and
down automatically.
2 Open the hinges on the filter cover.
3 Mount the filter cover on the designated screws and
push it backwards/forwards depending on the key
hole opening into the narrow section.
4 Tighten the fastening screws of the hinges.
Installation
en
49