Connect The Power Pack; Dismount The Attachment - Husqvarna WSC 40 Manuel D'utilisation

Both when the saw is used for flush cutting or normal
cutting, the spray guards are mounted in the direction of
chain rotation.
ASSEMBLING AND ADJUSTMENTS

Connect the power pack

WARNING! This product is only intended
!
for use together with the Husqvarna PP
400 series power packs. All other use is
forbidden.
Read through the manual supplied with the power pack
before starting to use the machine.
Maximum power to the unit is 9,2 kW and therefore 16 A
mode is shown when using WSC 40 with PP 480 and PP
490. This is automatically set when chain mode is
selected in the remote. Check that the power pack is
updated with latest software.

Dismount the attachment

WARNING! Always disconnect the power
!
cable to the saw unit before installation,
disassembly, cleaning and maintenance.
Carelessness can result in serious
personal injury or even death.
1 Disconnect the incoming power lead and incoming
water hose.
2 Remove the spray guards.
3 Place a hand on the chain to prevent it from moving
and loosen the bolt in the spindle hub with the 18 mm
wrench. Unscrew the bolt and make sure that the
spindle hub is in intermediate position.
4 Take a firm grip around the water connection on WSC
40. Unscrew the locking knob on the locking clamp.
Fold the locking clamp over to secure the parallel
handles.
5 Take a firm grip in the parallel handle with the free
hand. Pull out the spindle hub on the wall saw arm to
its outer position. Remove the machine.
6 Always keep the machine in the provided box when
not in use.
–
English 11