JUMO 705031 Notice De Montage page 50

2 Mounting
Dismounting, using the example of a multichannel controller module 705010 (at a central processing unit
705001)
Process:
1. Fully release the end bracket (D) using a screwdriver (D1), press upward from below, pivot toward
the front, and remove from the DIN rail.
Note: The end bracket does not need to be removed from the DIN rail if there is sufficient space to
the side to move it at least 20 mm to the right.
2. The cover (C) should be moved to the right (C2) until the side contacts of the neighboring module
are exposed. Then release the cover at the bottom using a screwdriver, press upward, and remove
from the DIN rail.
Note: The cover does not need to be removed from the DIN rail if there is sufficient space to the side
to move it at least 20 mm to the right.
3. Move the modules (B) on the right next to the multichannel controller module that is to be replaced
(A) a minimum of 20 mm to the right (B3).
These modules are isolated from the voltage supply and the system bus.
14
(E)
(A8)
(E5)
(F7)
(A) (B) (C) (D)
(A4) (B3) (C2)
(A)
(A6)
(F)
(D1)