JUMO 705031 Notice De Montage page 62

4 Retrofitting inputs/outputs
Overview diagram
(A)
Shutting down the system and removing the module insert from the housing
1. Shut down the system and disconnect it from the voltage supply.
2. Pull off all wired terminal strips (A) toward the front.
3. Push in the grooved surfaces at the top and bottom of the module insert (D) and remove the module
insert from the housing (E).
4. Remove the cover plate (C) of the relevant expansion slot (illustrated here for slot 1).
Retrofitting the module
1. Select the expansion slot: slot 1 (F), slot 2 (G), or slot 3 (H). The diagram shows the expansion slots
with modules already fitted.
2. Align the module (see illustration) and carefully insert it into the guide rails inside the housing (E) until
the connector engages.
Inserting the module insert into the housing and starting up the system
1. Hold the module insert (D) at the grooved surfaces on the top and bottom and insert the module in-
sert into the housing (E). When doing so, ensure that the board of the module insert slides into the
guide rails of the housing. Also ensure that the board of the retrofitted module slides into the guide
rail of the module insert (D).
2. Attach terminal strip (B) to the contacts of the retrofitted module and attach the label with the terminal
numbers to the terminal strip. When doing so, ensure that the numbering on the terminal strip match-
es the numbering on the front panel of the module insert.
3. Attach all wired terminal strips (A). Start up the system again.
4. Manually configure retrofitted inputs or outputs; the type of module (inputs or outputs) must also be
set. Do not perform wiring until this is complete.
5. Test the correct function of the complete plant under supervision.
26
(B) (D)
(C)
(E)
(F)
(H) (G)