Replacing The Gasket; Factory Default - Stahl EC-910-AFZ Serie Manuel D'instructions

9.2.2 Replacing the gasket

Replace the O-ring gasket of the product with the
one supplied.
Open and close the cover as described in the
chapters above.
Replace O-ring gasket paying attention to position it
correctly.
Fig. 27
24

9.2.3 Factory Default

It is possible to reset to the factory default settings.
The effect of the Factory Default procedure is the
same obtained through the web interface (Web
Interface manual, Tools Page, Hard Reset button).
Follow the procedure below:
• Disconnect the power supply to the unit.
• Open the housing and remove the slide.
• Set the reset dip switch to ON (SW1, 6.5 Housing
board description, page 18).
• Re-insert the slide and close the housing.
• Power the unit. Wait for 2 minutes.
• Disconnect the power supply to the unit.
• Open the housing and remove the slide.
• Set the reset dip switch to OFF (SW1, 6.5 Housing
board description, page 18).
• Re-insert the slide and close the housing.
• Power the unit.
Once the factory default procedure has
terminated, you need to configure the unit
as described in the relevant chapter (8.1
Default IP address, page 22).
MNTCMMX_2040_EN