Fuses Replacement; Replacing The Rear Cover Plate Gasket; Slide Replacing - Stahl EC-940S Serie Manuel D'instructions

12.1 Fuses replacement

CAUTION! For continued protection against
risk of fire, replace only with same type and
rating of fuse. Fuses must be replaced only
by service personnel.
The used fuse is described below.
FUSES REPLACEMENT
Power supply
12Vdc
24Vdc
24Vac, 50/60Hz
Tab. 14
As an alternative, use an approved fuse featuring the
same characteristics.
Tighten the screws that secure the slide to the
spacers on the bottom and disconnect the
connectors from the board.
FUS1
Fig. 23
32
Fuse (FUS1)
T 2A H 250V 5x20
T 2A H 250V 5x20
T 2A H 250V 5x20
12.2 Replacing the rear cover
plate gasket
In the event of o-ring gasket deterioration replace
it using the gasket supplied. In the absence of the
gasket provided, only use STAHL original spare parts.
Replace the gasket being careful to insert it correctly
into its housing.
Fig. 24

12.3 Slide replacing

Tighten the screws that secure the slide to the
spacers on the bottom and disconnect the
connectors from the board.
Fig. 25
MNTCMVXTHD_1606_EN