Stahl EC-910-AFZ Serie Manuel D'instructions page 9

INFO
Description of system specifications.
We recommend reading this part carefully
in order to understand the subsequent
stages.
• Before proceeding with installation, check the
supplied material to make sure it corresponds
to the order specification by examining the
identification labels.
• The equipment is intended for installation in a
Restricted Access Area by specialist technical staff.
• The manufacturer declines all responsibility
for any damage caused by an improper use
of the appliances mentioned in this manual.
Furthermore, the manufacturer reserves the right
to modify its contents without any prior notice.
The documentation contained in this manual has
been collected and verified with great care. The
manufacturer, however, cannot take any liability
for its use. The same thing can be said for any
person or company involved in the creation and
production of this manual.
• Since the user is responsible for choosing the
surface to which the unit is to be anchored, we
do not supply the fixing devices for attaching the
unit firmly to the particular surface. The installer is
responsible for choosing fixing devices suitable for
the specific purpose on hand. Use methods and
materials capable of supporting at least 4 times the
weight of the device.
• For all maintenance interventions, we recommend
you return the product to the laboratory that will
perform all required operations.
• This is a Class A product. In a domestic
environment this product may cause radio
interference. In this case the user may be required
to take adequate measures.
MNTCMMX_2040_EN
• To comply with the main supply voltage dips and
short interruption requirements, use a suitable
Uninterruptable Power Supply (UPS) to power the
unit.
• Device shall be supplied by PS2 energy source
• To feed the product use a safety transformer
and/or a voltage isolated power supply with the
appropriate characteristics. The characteristics
of output power must not exceed the following
values. Supply voltage: 24Vac (±10%) or 24Vdc
(±5%).
• In the case of a 24Vac power supply, you must
provide for adequate separation from the AC
power supply line using double or reinforced
insulation between the main power supply line
and the secondary circuit.
7