Safety Information - EdilKamin IRIS Manuel D'installation, Utilisation Et Maintenance

Dear Sir or Madam,
thank you for choosing our Iris stove.
Before using your stove, please read this booklet carefully so that you may exploit all its features to the full in complete safety.
Please remember that the 1st ignition must be carried out by the dealer, which verifies the installation and completes the guarantee.
The manufacturer cannot be held liable for any damage deriving from stove use following incorrect installation, incorrect maintenance
or misuse.

SAFETY INFORMATION

The stove is designed to heat the room it is installed in by radiation and by air movement from the front grilles. The heat is genera-
ted by automatic pellet combustion in the firebox.
The only risks which may derive from use of the stove are linked with non-compliance with the installation instructions, direct
contact with live electrical parts (inside) or with the fire or hot parts (glass, pipes and hot air outlet), and the introduction of
foreign substances. Only use pellets as fuel.
If components fail, the stove is fitted with safety devices which turn it off. This must be allowed to happen without interference.
For correct operation, the stove must be installed in compliance with the instructions on page 16 and the door must not be
opened during operation: combustion is managed automatically so no manual operations are needed.
Never put foreign substances in the firebox or hopper.
Do not use flammable products to clean the smoke duct.
Firebox and hopper components must only be cleaned using a vacuum cleaner.
The glass must be cleaned when COLD with a special product (e.g. GlassKamin) and cloth. Do not clean when hot.
Make sure the stove is installed and ignited by a qualified dealer, which must also complete the guarantee and take responsibility
for correct installation.
During stove operation, the outlet pipes and door reach high temperatures.
Do not keep objects which are not able to withstand heat in the immediate vicinity of the stove.
NEVER use liquid fuels to light the stove or rekindle the embers.
Do not block ventilation openings in the room where the stove is installed or air inlets in the stove itself.
Do not wet the stove, and do not put wet hands near electrical parts.
Do not fit reducers on the smoke outlet pipes.
The stove must be installed in a suitable place as regards fire regulations, and provided with all the facilities (power supply and
outlet) it requires for correct operation.
Before carrying out any maintenance, disconnect the device from the mains power supply.
- 14
-