Operating Features - EdilKamin IRIS Manuel D'installation, Utilisation Et Maintenance

OPERATING FEATURES

Iris is a pellet-fired stove which manages pellet combustion
electronically.
The fuel (pellets) is taken from the storage hopper (A) and
delivered to the combustion chamber (D) by a screw feeder (B)
driven by a gearmotor (C).
The pellets are ignited by hot air produced by a heating element
(E) which is drawn into the combustion chamber by a centrifu-
gal fan (M).
The combustion smoke produced is drawn out of the firebox by
the same centrifugal fan (M), and expelled from the nozzle (F)
at the bottom rear of the stove.
Air is blown into the hollow space at the back of the firebox by
a fan (G), where it is heated before coming out into the room
from the front grille (I).
The amount of fuel and the smoke extraction/combustion air
supply are controlled by an electronic circuit board in order to
achieve highly efficient fuel consumption.
There is a display-control panel (L) and two knobs on the front
panel under the door which allow all operating stages to be ma-
naged and displayed. The same functions may also be managed
by remote control (optional).
The pellet hopper is at the top of the stove.
The hopper is filled through a lid found at the back of the top
The internal structure of the stove is completely made of cast
iron.
The external covering is available in the following colours and
materials:
• ceramic: wine-red, grey, terracotta.
• ollite.
NOTES ON FUEL
The Iris pellet stove is designed to burn pellets.
Pellets are small 6 mm diameter (approx.) fuel cylinders made from sawdust and ground waste wood pressed at high
pressure without adhesives or other foreign material.
In order NOT to jeopardize stove operation, do NOT burn other substances. The use of other materials (including
wood), which can be detected by laboratory analyses, invalidates the guarantee.
EdilKamin has designed and tested the stoves for best performance with pellets with the following characteristics:
• diameter: 6 - 7 millimetres,
• maximum length: 40 mm,
• maximum moisture content: 8 %,
• heat output: 4300 kcal/kg (at least).
If pellets with different characteristics are used, the stove will need recalibrating (similar to the initial calibration
carried out by the dealer upon 1st ignition.
Use of unsuitable pellets may lead to: a decrease in efficiency; operating anomalies; stoppages due to clogging, dirty
glass, unburnt fuel, etc.
Pellets may be simply analysed just by looking at them.
Good: smooth, regular lengths, not very dusty.
Poor-quality: with horizontal and vertical splits, a lot of dust, highly variable lengths and mixed with foreign matter.
- 15
-