Entry Into Service - SODIMAS Qi touch 38SO011P00012 Documentation Technique

I. Entry into service
To enter a device equipped with a QI touch into service, every field in the assembly menu must be filled in.
With each field selected, a filter operates to suggest the most appropriate configuration for your installation.
- Where a full load device is concerned, the data are supplied in the installation plan. Start by entering the range
(medium, VMspeed, EEsy (machine room) and then the type of motor.
- Where a refurbishment is concerned, you must enter "modernisation" and then "synchronous" or "asynchronous"
motor.
The motor parameters then appear and allow you to enter all your motor's parameters.
Continue to enter the door data and then start the required learning operations. Each successful learning provides
access to the next learning.
Note: do not try to run learning operations in a different order. The board will block all operations.
QITouch
27SO021P00060 21/07/2017
62
Created by Sodimas - Photographs and illustrations not contractually binding - Subject to modi cation without prior notice
SODIMAS 11 rue Ampère 26600 PONT DE L'ISÈRE (FRANCE) - www.sodimas.com