SODIMAS Qi touch 38SO011P00012 Documentation Technique page 44

The protection and safety shutoff devices must comply with standard NF C 15-100 and must be part of the building
in which the product is installed.
Use the correct size fuses. ( FU1: 4AT, FU2: 3.15AT, 5x20mm)
The equipment must be connected to an electrical installation that complies with the applicable national
standards (NFC 15-100 in France). It must be equipped with protection against over-currents, over-voltages,
and grounding faults.
All equipment connected to the Qi touch board must comply with standard EN60950-1:2006 or its own
product standard.
Do not install the Qi touch board close to a source of heat or moisture. Do not obstruct the ventilation system
of the electrical box.
This product is only safe when it is used for its intended purpose.
Maintenance must only be carried out by qualified personnel.
Use this board exclusively inside a building or inside a sealed electrical box.
To avoid electrical chock, materials must be certified and usually calibrated
Dealing with end-of-life waste materials: Recycling is recommended for the packaging materials, papers,
plastics, metals, and electronic components, etc.
Ensure compliance with the collection, sorting, and recycling rules for packaging and end-of-life electrical
products (Packaging Directive 94/62/EC and WEEE Directive (RoHS and WEEE Directives 2002/95/EC and
2002/96/EC) => Waste Electrical and Electronic Equipment).
Created by Sodimas - Photographs and illustrations not contractually binding - Subject to modi cation without prior notice
SODIMAS 11 rue Ampère 26600 PONT DE L'ISÈRE (FRANCE) - www.sodimas.com
Needed to have individual protections (glooves, glass...) in case of measures of
voltage everywhere on installation.
QITouch
27SO021P00060 21/07/2017
44