Description Of The Menus; Step 1 Machine Room And Selection - SODIMAS Qi touch 38SO011P00012 Documentation Technique

H. Description of the menus
1. Mounting
This menu is the first one to use when starting your installation.
It contains all the data necessary for fitters to start the device, right through to normal operation.
A step counter allows you to locate where you are in the work to be done and to know what the next steps are.
Until step 7/8, landing and cabin calls are inoperative.
Here are the contents of each step:
STEP 1 "MACHINE ROOM AND SELECTION"
The choice of lift range pre-configures a part of the engine plate. Only the motors available within a range will appear.
If you are carrying out a refurbishment, choose modernisation and then your motor. Either a motor from the Sodimas
range (GT300 etc.) or a standard asynchronous or synchronous motor from another supplier. You must then fill in the
motor's parameters manually.
The "motor parameters" menus are filled in automatically and do not display when the motor is known.
Sodimas range
( VMSpeed, Medium, etc.)
OR "générique 81.20"
for devices other than
the Sodimas range but
subject to 81.20 OR
"modernisation" for
devices being modernised
Your device's commercial
load
Balancing your device
Mains voltage
Allows the direction of
rotation of the motor to
be reversed
Created by Sodimas - Photographs and illustrations not contractually binding - Subject to modi cation without prior notice
SODIMAS 11 rue Ampère 26600 PONT DE L'ISÈRE (FRANCE) - www.sodimas.com
QITouch
27SO021P00060 21/07/2017
Electrical / hydraulic
Name of the Sodimas
motor or "asynchronous"
for an asynchronous
motor other than Sodimas
or "synchronous" for a
synchronous motor other
than Sodimas
not present
Type of sensor used
Number of levels
57