Step 6 Speed Learning; Step 7 Solimax Learning; Adjustment - SODIMAS Qi touch 38SO011P00012 Documentation Technique

STEP 6 "LEARNING SPEED"
Speed learning is offered as soon as the "selection" parameter indicates absolute type counting.
This learning allows you to know the maximum speed usable in your installation.
The result is expressed in millimetres per second.
Note: the maximum speed is not necessarily the device speed. The speed of your device must be adapted in the
"adjustment, machine room, inverter, curve" menu.
STEP 7 "LEARNING SOLIMAX"
The levels learnt by the QI Touch board in step 4 must now be learnt by the secured sensor. You only need to validate
the levels in the car at each stop.
STEP 8 "LEARNING LOAD CELL"
Depending on the inverter used, the board suggests that the inverter does the weighing.
This procedure is compulsory for some full load devices such as VMSpeed or Vspace.
Follow the procedure and enter the maximum car weight to have better measuring accuracy.
2 Settings
This menu brings together all the adjustments possible via the QI touch. The data entered in the assembly are picked
up and distributed in the adjustment menus.
It is intended for fine adjustments, allocations of inputs/outputs when adding a function, time interval, equipment
configuration, etc.
Menus are created by the location in a shaft.
For example: a car display is in the car menu and then signalling.
contains adjustments for
car doors, car displays,
supervision, the button
box and dwell times
associated with the car
Extends the landing
menu. Allows adjustment
of all elements per level,
displays, fireman, altitude,
landing doors, fire, etc.
Contains adjustments
for the motor, brake,
trajectory, inverter,
mother board inputs/
outputs
Contains the set-up for
connections in the shaft,
the pit or the landing
Adjustment of the
selection type and
associated parameters
Groups together
standards (81.21, 81.20,
81.73, etc.) and optional
lift equipment (assistance,
multiplex, iso, etc.)
59