Landing Board (Can 1) - SODIMAS Qi touch 38SO011P00012 Documentation Technique

2. Landing board (CAN 1)

When a landing ribbon connector is used, each landing housing must be numbered, so that the corresponding level is
known. To do this, you must modify the addresses of each housing when fitting the ribbon cable.
- Allocation in simple access
The address of the lowest board will be "1". è
- Allocation in double passing access
In this configuration, B landings will be inserted in between levels.
For example, the OA level will be called 1 and 1B will be called 2.
It is then necessary to go into the menus: Adjustment, Level
Level 3
Level 2
Level 1
Level 0
3 B
(6)
2 B
(5)
0 B
(2)
Landing face B
Down push button = Landing 5 /
input C02
Down push button 0 = Landing 4 /
input C02
Up push button 0 = Landing 1 / input
C02
2 A
(4)
Car
1 A
(3)
0 A
(1)
Landing face A
Down push button 0 = Landing 3 /
input C02
Down push button = Landing 2 /
input C02
Up push button 0 = Landing 0 / input
C02
51