Lewmar 6 Manuel De Service page 23

SERVICING ONE SPEED WINCH 15ST
3
6
9
12
GB
1. Unscrew and remove the top cap, lift off the feeder
arm.
2. Remove the 2 retaining collets, to do so lift up the
main spindle
3. Lift off the drum.
4. Remove and clean the drum bearings and washer.
5. Remove and clean the gear spindle and gear.
6. To remove the main spindle, rotate it in a clockwise
direction as you lift it, also remove the ratchet gear.
7. Remove, clean and inspect the pawls and springs,
look for excess wear, replace if necessary. Lubricate
pawls with a light machine oil.
8. Lightly grease the ratchet gear, place it in position
with the ratchet facing up as shown.
9. Re-assemble in reverse order, remember to lightly
grease all gears, ratchet tracks, spindles and bearings.
10. Remove the three fixing screws holding the crown
assembly to the drum.
11. Carefully lift off the crowns and lift out the springs.
12. Remove, clean and inspect pawls and pawl springs,
look for excess wear, replace as necessary. Lubricate
pawls with a light machine oil. Re-assemble.
Page 23