VMI PULSE'R Prestige VENTILAIRSEC Notice D'utilisation page 44

Status screen
5.1.3 maintenance:
The correct functioning of the Hydro'R system depends on the functioning of your central heating
system and your water-supply network. During the annual maintenance of your heating system (boiler,
heat pump, etc.), you must inform your installer that you use a Hydro'R system. The installer must in
particular inspect the water filter installed upstream of your system. Your installer must therefore
place a "Hydro'R" logo on your heating system.
If your heating system supplies water hotter than 60°C and the water supply temperature does not
depend on the outside temperature, you will need to adjust the hot water temperature in mid-season
and lower it to less than 55°C, as shown in your boiler instruction manual. This will ensure optimal
functioning of the Hydro'R system and reduce your energy consumption.
Hydro'R care:
The Hydro'R system's warranty is only valid if a maintenance contract has been drawn up between the
user and the installer.
FAQ:
•
If there is no Hydro'R logo on your remote control, contact your installer.
•
If your Hydro'R system is leaking, close the system's water inlet valves and contact your
installer.
Shows the Hydro'R system's supply air temperature.
43