VMI PULSE'R Prestige VENTILAIRSEC Notice D'utilisation page 43

5.1.2 Presentation of the Hydro'R pictograms
Main screen
Set temperatures' setting screen
Hydro'R system operating (blue and red)
Hydro'R system not active (grey).
The outside temperature is higher than the set temperature.
Hydro'R system running with additional electric preheating
Hydro'R system not active but the electric preheating is used. The outside
temperature is very close to the Hydro'R set temperature; the heat is
provided by the resistors. You should not use the Hydro'R system in this
case.
Hydro'R set supply air temperature
The letter between brackets refers to the electric preheating mode
selected on the setting screen
- Cold (F)
- Economic (E)
- Comfort (C)
To choose the Hydro'R set preheat temperature.
Select the temperature with the buttons
by pressing
The preheating temperature of the Hydro'R is different
from the room temperature of the house. For your comfort
and a better reactivity of the heating in your house, we
advise you a preheating temperature of the Hydro'R at 28 ° C
which will allow a better comfort without harming the energy
consumption of the house.
Electric mode.
Used to choose the resistors' operating mode. The electric
preheating is activated if it is not possible to reach the required set
supply air temperature with the Hydro'R system:
- Cold (F) = 4°C
- Economic (E) = 15°C
- Comfort (C) = 18°C
Tip: for the most economic preheating, use the
4°C mode*
*this may lead to cold supply air
and confirm
42