switel TF535 Mode D'emploi page 21

Direct and speed dial numbers
You can store telephone numbers for direct dialing
on the red buttons M1, M2 and M3 (6). The direct
dial buttons are suitable for use as emergency call
buttons. An additional ten important numbers can
be stored as speed dial numbers.
Storing direct and speed dial numbers
1. Lift the handset.
2. Press the store button
3. Enter the telephone number using the number
pad. The maximum length is 16 digits.
4. Press the store button
5. Now press the required direct dial button M1, M2
or M3 or a button on the number pad (0-9) to
save the telephone number.
6. Replace the handset.
NOTE: Press the
pause in the telephone number.
Storage locations already used are deleted
automatically when you store a new telephone
number in this location.
The numbers stored can be recorded on the index
(5) underneath the display. For this purpose, the
cover can be removed with a pointed object.
Dialing using the direct dial buttons
1. Lift the handset and wait for a dial tone.
2. Press the Memory Button M1-M3, the stored
telephone number will now be dialed.
Dialing using the speed dial buttons
1. Lift the handset and wait for a dial tone.
2. Press the speed dial button
required storage location from 0 to 9 on the number
pad.
Recall
Press the recall button R (10) followed by the
extension number to transfer calls when connected
to a PBX (TBR only).
Access to additional network services can be
gained by using the recall button R,
Buttons. Contact your network operator for more
information.
Dialing and storing telephone numbers when
using private exchanges
NOTE: The pause function after an outside line
code described in this chapter is only required on
older private exchanges.
(8).
again.
button if you need to insert a
(7) and the
and #
With some private exchanges, there is a short
pause between the code for the outside line
(usually 0 or 9) and the dialing tone. When dialing
manually and when dialing using the direct dial and
speed dial buttons, this pause can be entered along
with the number so that the following digits are not
dialed too quickly.
Entering the pause when dialing manually
Press the (11) button once between the
number for the outside line and the actual
telephone number. The pause will be shown by a
"P" in the display.
After connecting to an outside line your telephone
will wait for three seconds before dialing the actual
telephone number.
Storing the pause
When storing a number, simply press the button
(11) after the number for the outside line and
before the actual telephone number. The pause will
be shown by a "P" in the display. When dialing with
the direct dial or speed dial buttons a pause of
three seconds will automatically be inserted after
the number for the outside line.
Mute
While talking, press
will not hear anything.
Amplification & Receiver volume control
The receiver volume can be boosted up to +35dB
max. during a conversation. Press the +35dB
button (12), and the Boost LED (13) will light.
You can increase the handset volume by turning
the volume slide switch
under the handset) to the required listening level.
You can turn off the boost function by pressing
the +35dB button at any time during your
conversation, the Boost LED will turn off and the
volume will return to normal level. When you
replace the handset to the cradle after the call, the
boost volume will be reset to normal automatically.
NOTE: Only press the +35dB boost Button if you
really need this additional amplification.
Warning: Setting your earpiece volume too high
can damage your hearing!!!
21
button (9), the other side
(14, located