Loading Cutlery And Dishes - Zanussi ZDT200 Mode D'emploi

3
Caution! Do not fill the rinse aid dispenser with
other products (e.g. dishwasher cleaning agent,

Loading cutlery and dishes

Helpful hints and tips
Caution! Only use the appliance for household
utensils that are applicable for dishwashers.
Do not use the appliance to clean objects that can absorb
water (sponges, household cloths, etc.).
• Before you load cutlery and dishes, do these steps:
– Remove all food remainings and debris.
– Make burnt, remaining food in pans soft.
• While you load cutlery and dishes, do these steps:
– Load hollow items (e.g. cups, glasses and pans)
with the opening down.
– Make sure that water does not collect in the con-
tainer or in a deep base.
– Make sure that cutlery and dishes do not lie inside
one another.
– Make sure that cutlery and dishes do not cover other
cutlery and dishes.
– Make sure that glasses do not touch other glasses.
– Put small objects in the cutlery basket.
• Plastic items and pans with non-stick coatings can
keep water droplets. Plastic items do not dry as well
as porcelain and steel items.
• Put light items in the upper basket. Make sure that the
items do not move.
Caution! Make sure that the spray arms can move
freely before you start a washing programme.
Warning! Always close the door after you load or
24
4
liquid detergent). There is a risk of damage to the ap-
pliance.
Adjusting the dosage of rinse aid
unload the appliance. An open door can be dangerous.
1
Arrange service dishes
and large lids around the
edge of the lower basket.
3
The rows of prongs in the
lower basket can be flat to
load pots, pans and bowls.
The rinse aid dial is set at
the factory at position 3.
To increase or decrease
the dosage refer to 'What
to do if...'
2