Use Of Dishwasher Salt; Use Of Rinse Aid - Zanussi ZDT200 Mode D'emploi

– The end indicator light flashes to show the level
of the water softener.
Example: 5 flashes, pause, 5 flashes, pause, etc...
= level 5.

Use of dishwasher salt

Caution! Only use dishwashers salt. Types of salt
that are not applicable for dishwashers cause
damage to the water softener.
1
3
Fill the salt container with
1 litre of water (only the
first operation).

Use of rinse aid

Caution! Only use branded rinse aid for
dishwashers.
Do these steps to fill the rinse aid dispenser:
2
4
7. Press the programme selection/cancel button one
time to increase the water softener level by one step.
8. Press the on/off button to save the operation.
5
It is normal that water overflows from the salt con-
tainer when you fill it with salt.
Make sure that there is no grain of salt outer of the
salt compartment. Salt which stays on the tank for
a while drills the tank. It is recommended to start a wash-
ing programme immediately after you fill the salt con-
tainer. This prevents of corrosion because of spilled salt.
When you set electronically the water softener to level 1,
the salt indicator light does not stay on.
1
6
2
23