Threading The Machine (3 Threads) - Janome FA4 Manuel D'instructions

Threading the Machine (3 threads)

Using the needle on the right only
(for regular three-thread serging)
When you use the right needle, the standard sewing
width is 3.5 mm.
The illustration on the left shows you how to thread
the needle.
Note:
Tighten the needle clamp screw on the side that is
not being used to prevent losing the screw.
q Changeable thread guide
q
Using the needle on the left only
(for wide three-thread serging)
When you use the left needle, the standard sewing
width is 5.7 mm.
The illustration at left shows you how to thread the
needle.
q Changeable thread guide
q
64