Units Selection; Counting Mode - Baxtran BAP Mode D'emploi

ELIMINATE THE TARE WEIGHT
To eliminate the tare weight by pressing
Note:
1. When performing the tare operation(s), make sure the instrument is in stable.
2. If consecutive tare operations have been performed, to clear the tare value, please remove all the
containers on the pan first and then press
3. Tare range is the full capacity of balance for all models.

4.2.3 UNITS SELECTION

Press key to choose the weighing units and the display will be changed to the new value
with the units shown. There are up to 13 units of weight that can be enabled. Refer to Parameter
Set-up Section.

4.3 COUNTING MODE

In normal weighing mode, press
Press the key to select the sample size from 10, 20, 50, 100, 200, 500 y 1000.
SAMPLING
Put on some samples with a sample size the same as the current displaying one. Then
press the
the display shows as below:
Take off the samples on the pan. The sampling operation is finished. Then the balance
can be used for counting.
Press
returns to weighing mode will bring back to counting mode and the unit weight data is
still stored for use).
Note:
1. If a container needs to be used, press TARE key to subtract its weight before entering into the
counting mode.
2. If the unit weight is too small (less than 0.2 of a scale division), the display will show: --or-- PCS.
key to enter into counting mode, and the display shows the sample size:
key and the displayed value starts flickering. Several seconds later,
below:
key to return to normal weighing mode (Pressing
Key with no object on the scale.
key.
USER MANUAL BAR
key after it
EN EN
7