Weighing Accumulation Function; Hold Function; On/Off Save Power; Remote Channel Selection - Baxtran STE Série Manuel D'utilisation

5.3 TARE/ZERO
To make a tare, place the weight to be tared on the hook, once you have the stable weight press the key
remote control and the weight will be tared in the crane scale memory. If in the crane scale we do not have anything the weight should be
zero, if it shows us some weight being empty we will use the ZERO option, in this way it will return to zero by pressing the
the crane scale.

5.4 WEIGHING ACCUMULATION FUNCTION

When the reading of the display is stable and weighing more than 20 divisions, press the
weighing carried out and so on consecutively pressing the
("n32" example) , after 2 seconds the crane scale returns to the normal weighing mode. To display the last weigh as well as the last total
press the key at any time.
To cancel the weight accumulation function, press the

5.5 HOLD FUNCTION

1. Press the key
2. Press again the key
mode.
5.6 ON / OFF SAVE POWER
If the scale remains at zero and inactive for one minute, the screen will go blank depending on battery saving (only one circulating point will
appear at the bottom of the screen). As soon as the crane scale is activated again or a key is pressed, the display will show the current load
value again.

5.7 REMOTE CHANNEL SELECTION

1. With the hook off, press the keys
2. The display will show "Dsp 1". (Function not available)
3. Press the key
Now the display will show "CHX " ("X " representing the current channel "0-7 ")
4. Press to select a channel and press
The display will show "Ft0 ". Command Settings.
5. Keep at "0 ". Press
Note: The channel is already configured with the corresponding control for each hook. Only configure couando the control is
controlled when a charge of commad is made.

6. CALIBRATION

1. Power on the crane scale and press the
2. Press key on remote control once to display "CAL00".
3. Do not hang on the hook any goods at this time, press
4. Display will show "LOAD", press the
5. Press the key on remote control to input the calibration weight value (long press
of digit, click to the left shift).
6. Lifting weights, until steady 4 to 5 seconds.
7. Press the key on remote control to show " ",2 seconds after the
display of the hanging weight values, calibration is finished, put weight down, turn it off and turn it on again.
on remote control, the display´s reading will remain locked for 30 seconds.
on remote control, the Hold function will be turn off, the crane scale will return to normal weighing
and the key
to go to the next parameter.
to go to the next and last setting.
to return to weighing mode and restart the device.
until visualized "CAL SP".
key on remote control view " " and then later on display "LOAD".
key on each weighing scale we will visualize the number of accumulations
key on the remote control to return to the normal weighing mode.
at the same time.
key.
USER'S MANUAL STE
or the
key on the remote control to accumulate the
key on remote control to increase the number
EN
key on the
button of
5