Disposal And Declaration Of Conformity - Klarstein 10011602 Mode D'emploi

Before using,please pay attention to the instruction as below.
1. Power on.
Plug the appliance with power supply,
after 1S .
2. Procedure setting and heating
1) Time setting for heating
Press Time key once, the time will be 1 hour more. Press Time for more than 1 S, time fi gure will
increase by hours continuously and stop after no pressing. The time setting circle is 0-15 hours.
2) Heating
After time setting, press Start/Stop key to start heating and count down fi gure will show in LCD
display.
For example:
Time setting for 5 hours,
then 1 hour,
3. Stop heating
A) Stop heating automatically
When count down is over, appliance stops heating automatically then in standby. Meanwhile,
shows in LCD.
B) Stop heating manually
When appliance is in heating situation, press Start/Stop key and appliance is in standby directly.
Meanwhile,
1. Rating voltage:220-240V/230V~50Hz/60Hz
3. Ambient working temperature:5-40 ℃,ambient humidity≤80%
2. Rating power:21.5W

Disposal and Declaration of Conformity

According to the European waste regulation 2002/96/EC this symbol on the product
or on its packaging indicates that this product may not be treated as household was-
te. Instead it should be taken to the appropriate collection point for the recycling of
electrical and electronic equipment. By ensuring this product is disposed of correct-
ly, you will help prevent potential negative consequences for the environment and
human health, which could otherwise be caused by inappropriate waste handling of
this product. For more detailed information about recycling of this product, please
contact your local council or your household waste disposal service.
Producer: Chal-Tec GmbH, Wallstraße 16, 10179 Berlin, Germany.
This product is conform to the following European Directives:
2004/108/EC (EMC)
2011/65/EU (RoHS)
2006/95/EC (LVD)
Use
shows in LCD and "Hr" keeps winking; when count down fi gure is less
shows in LCD and "Min" keeps winking.
shows in LCD.
Specifi cation
will show in LCD display and it will be in standby
10