Display Indications And Symbols - VOLTCRAFT LCR-400 Mode D'emploi

6. DISPLay INDICaTIoNS aND SyMBoLS

A Bar chart shows utilisation of the measured range in %
B Main parameter for measuring operation
s = serial for serial circuits in AC operation (Ls, Cs, Rs)
p = parallel for parallel circuits in AC operation (Lp, Cp, Rp) DCR = Direct current resistor (DC)
C Function and operating displays
Max Shows the maximum measured value
Min Shows the minimum measured value
CAL Shows calibration mode
Sorting Shows sorting mode
Tol Shows the pre-set tolerance range for sorting
Battery icon Shows the battery status in battery operation
120 100 kHz Shows the measuring frequency
D Measuring functions
HOLD Data hold is active. The displayed measured value is recorded AUTO automatic measuring
operation with preselection of the measuring parameters (L, C, R)
AUTO LCR Smart automatic measuring operation without pre-selection of the measuring parameter
RANGE Range display in sorting mode
REL Reference value display mode
E Main display with measuring units
F Sub-display with measuring units
G Sub-functions for the sub-display
ESR Equivalent serial resistor
RP Equivalent parallel resistor
DQθ D = dissipation factor , Q = quality, θ = phase angle
33