Loading The Print Ink Cartridge - Fujitsu fi-412PR Guide De L'utilisateur

2.2. Loading the Print Ink Cartridge

Load the print ink cartridge as follows:
When installing or replacing the print cartridge, be
ATTENTION
careful not to insert it out of place.
1. Confirm that the scanner is turned off.
2. To open the cover, grasp and pull open the center
of the Print Cartridge Cover turning it open
towards you.
3. Remove by pulling the tape seal that is affixed to
the Print Cartridge Holder and the Paper Guides.
4. Pinch slightly together the handles with your
fingers, as shown below, to release it from its
cartridge tray holder and turn it upwards to open
the tray holder.
5. Remove the new print cartridge from its pouch.
6. Remove the protection tape from the print
cartridge.
Print Cartridge Holder
Do not touch the metal part of the cartridge nor put
ATTENTION
the tape back on again.
7. Place the Print Cartridge into the holder as shown
below.
Be careful not to let the Print Cartridge touch
ATTENTION
or catch onto the print circuit film.
8. Lower the handle until it locks in and fixes the
cartridge in place.
9. Position the Print Cartridge Holder along where
the document will pass through.
The print will be located on the page properly for
your application.
10. Close the print cartridge cover.
fi-412PR Imprinter Operator's Guide | 7