Operation Test - Fujitsu fi-412PR Guide De L'utilisateur

2.3. Operation Test

After installing the Imprinter, check if the printing
operation can be done in the Offline Print Test mode of the
scanner.
1. While pressing the [Function] button on the
operator panel, press the
Continue pressing the [Function] button.
2. Release the [Function] button when the Function
Number Display changes from [P] to [b].
Function
Function
Send to
Function Number Display
Scan
3. Place a blank document into the ADF paper
chute.
Use A4 or Letter size paper. If the size is
ATTENTION
smaller than A4 or Letter, printing may not
complete successfully.
Confirm that the Print Cartridge is
positioned within the document width.
4. Press [Scan] button to test.
The paper will feed into the ADF, and the Imprinter
will print out the Print Test Characters starting at
5mm from the paper's edge
8 |
button.
Function
Print Test Patterns
HINT
Test Pattern 1 (Horizontal):
ABCDEFGHIJKLMNOPQRSTUVWXYZ[\]^_`00000000
Test Pattern 2 (Horizontal）:
abcdefghijklmnopqrstuvwxyz{|}~ 00000000
Test Pattern 3 (Horizontal):
!"#$%&()*+,-./0123456789:;<=>?@00000000
Test Pattern 4(Vertical):
ABCDEFGHIJKLMNOPQRSTUVWXYZ[\]^_`00000000
Test Pattern 5 (Vertical):
abcdefghijklmnopqrstuvwxyz{|}~ 00000000
Test Pattern 6 (Vertical):
!"#$%&()*+,-./0123456789:;<=>?@00000000
When multiple sheets of documents are placed in the
ADF, the Test Print repeats patterns from 1 through 6.
The numbering data portion "00000000" changes from
0 (Zero) with increment of 1(one).
(One test pattern is printed at a time. Press the [Scan]
button to continue printing the next test pattern.)
Print Test Sample
5. To stop Offline Print test mode, press the
button. The scanner will switch off.
5mm