Installing The Print Cartridge - Fujitsu fi-565PR Guide De L'utilisateur

10. Replace the Stacker (removed in procedure 2)
into the Imprinter.
Insert one end.
11. Connect the power cable to the scanner.

2.2. Installing the Print Cartridge

Mount the print cartridge as follows:
When installing or replacing the print cartridge, be
ATTENTION
careful not to insert it out of place.
1. Confirm that the scanner is turned off.
2. To open the print cartridge cover, grasp and pull
open the center of the cover turning it towards
you, as shown below.
3. Remove by pulling the tape seal that is affixed to
the print cartridge holder and the paper guide.
4. Pinch slightly together the handles of the closing
lever to release it from its cartridge tray holder
and turn it upwards to open the tray holder.
Insert the next end.
Print Cartridge Holder
5. Remove the new print cartridge from its pouch.
6. Remove protection tape from the print cartridge.
Do not touch the metal part of the cartridge nor
ATTENTION
put the tape back on again.
7. Insert the print cartridge into the holder as shown
below.
Be careful not to let the print cartridge touch or
ATTENTION
catch on to the print circuit film.
8. Lower the handle lever until it locks in and fixes
the cartridge in place.
9. Position the print cartridge holder along where the
document will pass through.
The print will be located on the page properly for
your application.
fi-565PR Imprinter Operator's Guide | 7