Packaging, Storage And Transport; Delivery Status; Packaging And Transport; Storage - Wessamat Blue-Line Série Mode D'emploi

3. Packaging, storage and transport

3.1 Delivery status

The machine is supplied completely pre-assembled. The corresponding operating fluids (e.g. refrigerant) are
already contained.

3.2 Packaging and transport

After unwrapping the machine, keep the original packaging if possible. If the machine has to be dispatched (e.g.
return for repair), the original packaging should be used if possible. Please indicate the position of the machine
within the packaging on the outside of the packaging. ( „↑Top ↑" )
If the machine has to be dispatched or relocated, please also note the instructions in the previous sections.
CAUTION: In order to completely empty the water from the ice production trough, switch the machine to Position
"Produktion aus/off" at the production switch. If ice cubes are present on the evaporator fingers, please wait until
these detach of their own accord and fall into the storage container. Now remove the ice cubes from the storage
container and wipe out the container with a cloth in order to remove residual moisture. Close off the water
supply, pull out the power plug and separate all hose connections.

3.3 Storage

E
If your machine is not immediately installed or commissioned after delivery or relocation, it should be stored in a
N
dry place and at temperatures above freezing.
G
L
I

4. Technical data and machine description

S
C

4.1 Identification

H
The identification plate is in the inside of the machine under the cover, on the technical equipment compartment.
There is also a further identification plate in the inside of the storage container, at the top on the left.
E
N
G The CE mark is located at the front of the ice cube maker.
L
The information provided on the identification plate matches the machine specification (see page 3).
I
S

4.2 Machine equipment and accessories

H
The ice cube maker is standard supplied with:
•
operating instructions,
A
•
water supply tube,
N
•
plastic angle,
G
L •
water drain tube,
A
•
cooling water drain tube (only for water-cooled units),
I
•
adjustable feet,
S
•
ice scoop.

4.3 Noise level

The continuous sound pressure level emitted by the machine is < 70 dB(A).
Depending on local conditions, higher sound pressure levels may occur.
28