Construction Characteristics - baltur TBG 35 PN Notice D'instructions

TECHNICAL SPECIFICATIONS
E
N
THERMAL CAPACITY
G
OPERATION
L
NOx EMISSIONS
I
S
FAN MOTOR
H
ABSORBED ELECTRICAL POWER*
IGNITION TRANSFORMER
POWER SUPPLY VOLTAGE
PROTECTION RATING
FLAME DETECTOR
NOISE**
WEIGHT
Natural Gas (G 20)
FLOW RATE
PRESSURE
*) Total absorption at start with ignition transformer on.
**) Noise levels measured in the laboratory of the manufacturer with burner running on test boiler, at maximum nominal
thermal output.
STANDARD ACCESSORIES
BURNER COUPLING FLANGE
INSULATING GASKET
STUD BOLTS
HEXAGONAL NUTS
FLAT WASHERS

CONSTRUCTION CHARACTERISTICS

The burner consists of the following parts:
• Air intake with butterfly gate for adjusting the combustion air flow
rate.
• Mounting flange to the sliding generator, to adapt the protuberance
of the head to various types of heating generators.
• Air pressure switch to ensure the presence of combustion air.
• Minimum and maximum air flow adjustment for first and second
stage by means of electric servomotor.
• Gas train complete with security valve and proportional function-
ing, pneumatic functioning, minimum pressure switch, pressure
regulator and gas filter.
• Flame detection by ionisation electrode.
• Automatic command equipment and burner control according to
European regulation EN298.
• Connection to gas train with fail safe connectors.
MAX kW
MIN kW
Modulating / Progressive two
< 80 (Class III according to EN
mg/kWh
kW
r.p.m.
kW
26 kV - 40 mA - 230/240 V - 50/60
1N ~ 230 V ±10%- 50 Hz
dBA
kg
MAX m³n/h
MIN m³n/h
MAX mbar
• 7 pole plugs for the electricity and thermostat supply of the burner,
4 pole plug for the command of the second stage of functioning
or electric power regulator.
• Suitable for microammeter connection to the ionisation cable.
• Electrical protection rating IP40.
4 / 20
0006081437_201005
TBG 35 PN
410
80
stage burner
676)
0,37
2760
0,56
Hz
IP 40
IONIZATION PROBE
76
40
41,23
8,05
360
TBG 35 PN
2
1
N° 4 M 12
N° 4 M 12
N° 4 Ø 12