baltur TBG 35 PN Notice D'instructions page 10

Bruleur de gaz a deux allures progressives/modulant
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

E
N
G
L
I
S
H
ASSEMBLING THE GAS TRAIN
There are different possible assembly configurations for the gas
train according to the different installation requirements, as shown
in the diagram (8, 8a, 9). The burners are supplied with gas train
connections facing downwards.
Due to the air-gas command devices and their relative fixed con-
nections there are only two solutions for TBG 35P, (8 e 8a).
Only the TBG 35 can provide for the assembly of the gas train ac-
cording to configuration 9.
PREPARATION FOR CONNECTION WITH TRAIN TURNED
UPWARDS (TBG 35)
If you wish to turn the train entrance upwards, before applying the
burner to the boiler, follow the subsequent procedure.
1) Following the instructions detailed in the "Maintenance" para-
graph, extract the mixer assembly and remove the screw (1)
which connect the the unit's forward movement rod (2) to the
gas delivery pipe (3) passing through the hole (4) made in the
bend coupling (figure 1).
2) Turn the bend coupling through 180° in such a way as to match
the gas delivery pipe to the hole (4a) made in a diametrically
opposed position to the coupling itself. Reconnect the unit's for-
ward movement rod (2) and the gas delivery pipe (3) with the
screw (1) in figure 1.
3) Now remove the 4 nuts (5) in figure 2, disassemble the flame
pipe (6) and, after having unscrewed the lung (7) from the rela-
tive stud bolts, reposition them with the threaded connection for
fixing the gas train upwards.
4) To complete the operation fix the flame pipe (6) and the lung (7)
with the 4 nuts (5), finally reposition the mixing unit in the rela-
tive housing.
At this point it is possible to install the burner in the boiler with
the valve train as shown in configuration 9 illustrated in paragraph
"Gas train assembly".
Rigid pipe fixing screw
Pressure tap in
the combustion
chamber
Pressure transmission pipe in
the combustion chamber
8 / 20
0006081437_201005
Rigid pipe detecting
pressure in the combustion chamber
Cut in line with diffuser
Fig.1
Fig.2

Publicité

Table des Matières
loading

Table des Matières