Unpacking And Inspection; Unpacking; Handling Notes - Star TSP400 Guide D'installation

1. UNPACKING AND INSPECTION

1-1. Unpacking

Check each item in the box against Figure 1-1 to make sure that you have
everything (there should be five items).
If any of these items are missing, contact your supplier.
Printer

1-2. Handling Notes

Before you start setting up your printer, make sure that you have a suitable place
in which to locate it. By "a suitable place", we mean:
• Close to an easily accessible socket-outlet.
• A firm, level surface which is fairly vibration-free
• Away from excessive heat (such as direct sunlight, heaters, etc)
• Away from excessive humidity
• Away from excessive dust
• With access to a steady power supply that is not subject to power surges. For
example, do not connect the printer to the same circuit as a large, noise-
producing appliance such as a refrigerator or an air conditioner.
NOTE: Make sure that the line voltage is the voltage specified on the printer's
identification plate.
Sample paper roll
Paper-roll shaft
User's manual
Installation Manual
Fig. 1-1
– 1 –
Ø24mm
Ø28mm
Ferrite core
Ferrite core for
for peripheral
interface cable
unit cable
(E.U. only)
(E.U. only)
fastener
(E.U. only)