First Use Preparation And Set-Up - mspa BAIKAL Manuel D'utilisation

REF. NO.
A
B
C
D
E
F
G
H
I
J
K
L
NOTE: When ordering parts, be sure to quote the model number, part numbers and description.

FIRST USE PREPARATION AND SET-UP

Site preparation and requirements
The spa can be installed indoors and outdoors. For household use only.
The spa must be set up on a flat, smooth, and firm surface that is capable of supporting the maximum load
of the filled spa with the listed number of maximum occupants.
Make sure the area is free of sharp objects under or around the spa. Uneven or unsound surfaces can
damage the spa and void your warranty. Level the surface before filling the spa with water.
Provide adequate drainage system around the spa to deal with overflowing water and splashes.
Make sure there is enough clearance around the spa for full access to the spa equipment for maintenance
Additional requirements for indoor installation
qualified contractor or structural engineer to verify the requirement.
any other material that could be damaged by the moisture.
moisture to escape. Install a ventilating system to prevent excess condensation moisture in the room.
PARTS DESCRIPTION
Spa cover with aluminum foil inside
Spa tub
Wired controller
Inflation hose for bladder
Filter cartridge*2, cartridge base
Inflatable bladder
Spa drain valve adaptor
Wrench
Repair kit
Buckle spa cover and ground mat set
11
QTY.
1
1
1
1
1
1
1
1
1
1
1
1